COURSE CONTENT
√ Correct use of test and measuring instruments
√ Drawing , Reading and Interpretation of electrical drawings
√ Symbolic representation of industrial electrical devices
√ Application of switches and development and testing of logic circuits
√ Meggar and its applic ations, testing of motor and cables
√ Protection circuits - Fuses, MCB, MCCB, MPCB, ELCB, Overload relay and its testing
√ Electromagnetic contactor and relay, its testing, development and testing of simple start/ stop control circuit and latched circuit
√ DOL starters for three phase induction Motor
√ Timer - ON delay, OFF delay and cyclic testing of its working , Star - Delta starter for induction Motor
√ Development of Different types of logical circuits used in industrial application
√ Pressure switch and its application in automatic pressure control change Circuit in air compressor
√ Simulation of Elevator control circuit
METHODOLOGY
The programme consists of a mix of :
- √ Lectures and presentations
- √ Demonstrations
- √ Interactive discussions
- √ Hands-on practice
ABOUT CRISP
CRISP is established under Indo-German Cooperation agreement as an autonomous organisation of the Dept. of Technical Education and Skill Development, Govt. of M.P. CRISP provides technical training and consultancy services for Industry Personnel, Government Officers, Faculties of academic and teaching institutions, Students and Jobseekers. CRISP is equipped with the state-of-the-art equipment and technology, latest software, qualified, trained and experienced trainers in the relevant fields. CRISP has its head office in Bhopal and training centres at several national and international locations.
INTRODUCTION OF COURSE
The new era of Industrial Automation has led to the acquisition of sophistic a ted electrical controls. To derive maximum potential from these electrical controls, it is necessary to keep them fully oper ational. The Industrial Personnel are expected to be proficient not only in the use of these controls but should also be able to main tain them properly and attend to minor faults. Keeping these aspects under consider ation, CRISP has set up state of the art facilities to impart training in this area.PRE-REQUISITE
| Industry personnel with rele vant experience. | |
| Passouts or students pursuing Degree/ Diploma in Electronics/ Electrical/ Instrumentation Engineering or equivalent |
DURATION
- √ Full time : 5 working days (7 hours/ day )
- √ Part time : Four weeks (20 working days, 2 hrs./day
Course Fee
| Kindly refer to our training calendar at www.crispindia.com or can be obtaind from CRISP counselling desk |
Learn Mode
Off Campus Training |
Online Training |
| Join Now |
