COURSE CONTENT
√ Test and measuring instruments - Analog and Digital Multimeters , Oscilloscope , Function generat or, LCR meter, Digital Storage Oscilloscope, IC testers.
√ Identification and testing of electronic components - resistors, preset, potentiometer, capacitors, trimmer, coil, trans former, fuses, diodes, zeners, transis tors, IGB T, SCR, triac, digital and analog ICs.
√ Assembly and testing of basic electronic circuits (on bredboard and general purpose PCB using soldering)
√ Testing and troubleshooting of regula ted and switch mode power supplies
√ Assembly and testing of Op - Amp / Digital Electronic circuits
√ Interpretation of analog and digital electronic circuits used in industrial equipment
√ Soldering and desoldering of SMD components
√ Introduction to Electronic design and simulation software
√ Safety precautions in handling Electronic circuits
METHODOLOGY
The programme consists of a mix of :
- √ Lectures and presentations
- √ Demonstrations
- √ Interactive discussions
- √ Hands-on practice
ABOUT COURSE
CRISP is established under Indo-German Cooperation agreement as an autonomous organisation of the Dept. of Technical Education and Skill Development, Govt. of M.P. CRISP provides technical training and consultancy services for Industry Personnel, Government Officers, Faculties of academic and teaching institutions, Students and Jobseekers. CRISP is equipped with the state-of-the-art equipment and technology, latest software, qualified, trained and experienced trainers in the relevant fields. CRISP has its head office in Bhopal and training centres at several national and international locations.
INTRODUCTION OF COURSE
Modernisation has led to the acquisition of sophisticated electronic equipment . To derive maximum potential from these equipment it is necessary to keep them fully operational. Professionals are expected to be competent not only in the use of these equipment, but should also be able to main tain them properly by at tending to minor faults and trouble shooting the faulty equipment. CRISP has set up facilities to impart training in this area. After completing this course, the participants will be able to handle maintenance jobs with greater confidence.PRE-REQUISITE
| Industry personnel with rele vant experience. | |
| Passouts or students pursuing Degree/ Diploma in Electronics/ Electrical/ Instrumentation Engineering or equivalent |
DURATION
- √ Full time : 5 working days (7 hours/ day )
- √ Part time :: 3 weeks (15 working days, 2 hours/day)
Course Fee
| Kindly refer to our training calendar at www.crispindia.com or can be obtaind from CRISP counselling desk |
Learn Mode
Off Campus Training |
Online Training |
| Join Now |
